Fender Line Tidy
A J-hook with a Ø32mm round throat on a 92mm back plate, for hanging coiled fender lines and loose ends in a locker or on a pontoon board — the round throat takes a coil of 10–12mm line without kinking it, and the upturned lip stops the coil rolling out. Two open screw slots sit side by side at the top of the plate, both facing up: drop it onto two pre-driven screws, nip them up with washers, and the hanging load pulls the slots harder onto the screws. Let us be precise about what it is NOT, because the marine service page says the same: it is a line tidy, not a cleat and not a mooring fitting — nothing that holds a boat should ever be printed plastic, and we will not print one. For stowage duty PETG is plenty; ASA if it lives in the cockpit sun. One constant cross-section, printed standing, no support beyond the two 5mm slot roofs, which are short bridges.
from £11.29example, in PLA
Example pricing
A guide only — not a fixed quote. Final price depends on material, quantity, print orientation and printability.
| Material | 1 unit | 5 units | 10 units | 25 units |
|---|---|---|---|---|
| PLA | £11.29 | £47.43£9.49/unit | £85.83£8.58/unit | £191.99£7.68/unit |
| PETG | £11.90 | £49.99£10.00/unit | £90.46£9.05/unit | £202.34£8.09/unit |
| ABS / ASA | £13.25 | £55.66£11.13/unit | £100.72£10.07/unit | £225.30£9.01/unit |
Per-unit prices fall with quantity. Larger batches are cheaper still — ask for a bulk quote.